Write the mesh equations for this network.,
I am still new with this program so I am not sure how or if it is possible to set the inductor and capacitor to there impedance values. I know in multisim and in icircuit it isn't possible to set impedance values. Everything on the below circuit has the following values.
E1=5V @ 30 deg R=50 ohm @ 0 deg Xl=20 ohm @ 90 deg E2=20V @ 0 deg Xc=60 ohm @ -90 deg
simulate this circuit – Schematic created using CircuitLab
Here is my process, can I get feedback on where I am going off track.
I start with the left side of the circuit in the bottom left corner and go around.
E1+R(I1)+Xl(I1)+Xl(I2)-E2 Thats it for the first loop ... For the second loop
E2+XL(I2)+Xl(I1)+Xc(I2) Thats it for the second loop.
Do these formulas look correct?
I am still new with this program so I am not sure how or if it is possible to set the inductor and capacitor to there impedance values. I know in multisim and in icircuit it isn't possible to set impedance values. Everything on the below circuit has the following values.
E1=5V @ 30 deg R=50 ohm @ 0 deg Xl=20 ohm @ 90 deg E2=20V @ 0 deg Xc=60 ohm @ -90 deg
simulate this circuit – Schematic created using CircuitLab
Here is my process, can I get feedback on where I am going off track.
I start with the left side of the circuit in the bottom left corner and go around.
E1+R(I1)+Xl(I1)+Xl(I2)-E2 Thats it for the first loop ... For the second loop
E2+XL(I2)+Xl(I1)+Xc(I2) Thats it for the second loop.
Do these formulas look correct?
No comments:
Post a Comment